This cost includes everything you need to make the doll, including pillows, tape, safety pins, and other things you have at home. If you want to buy new towels for this love doll project, you will need two sets. In this step, you do the same thing but with a smaller round cushion. For the loot compartment, you love use a chip can or a cardboard paper towel roll, or place the bottom bedding directly inside the pillow to narrow the opening. To do this, cut the seam at the bottom of the pillow.
If you only have a square pillow, that’s okay too. To give the pillow a more rounded look, use your fingers to press each corner of the pillow. To maintain this shape, use a small piece of flex tape.
bottom of the large pillow. The needle will hold everything together. However, you can pin the butt to the torso so it won’t stay in place. Next, take a belt or rope and wrap it around the center of the large pillow and over the small pillow. This will create the waist of your homemade sex doll.
Next, attach your breasts to a thin bra and place it around the top of a king-size pillow, hooking the bra in the back and adjusting the shoulder straps to grab the top of the pillow. If you want, you can use flex tape or small safety pins to secure the straps in place. But love has to hold everything in place.
For the thighs, you should use a thicker towel than for the arms and legs. So try different thicknesses and sizes of towels: beach towels, fluffy bath towels, etc. Take two towels and roll them lightly. Then roll the kitchen towel longer. After rolling, put tape on the top and bottom of the towel to prevent it from rolling again. You should still be able to access the bottom of the doll and reach inside. Set those aside.
Do the same with the bath towels to form the legs of your homemade love. Roll up the four towels tightly, then roll the towels for the top legs thicker. Wrap tape around each roll to prevent them from falling apart. Be careful not to tape too tight, though, as this will change the shape of the doll’s legs. Again, make sure you still have access to the ends of the towel so you can attach it before you start making your DIY love. Please note that these steps are not set in stone, so if you have a great idea for how to make your doll look better, feel free to modify it. Take the towel and lay it on a wide surface so it is easy to work with. Unzip the towel to make it easier to access the holes for the arms and legs. First, slip a short towel into the sleeve over the towel. If you have any problems, you can add some tape to make it work. Next, insert the doll’s legs. Take a thick towel and thread it through each leg opening and over your lover’s body. Once in place, take a thin towel and thread it through the ankle openings of each leg. The leg openings are usually very narrow, so you may need to cut a slit along the seam to make it easier to insert. You can always use black flex tape to close it later.
You should now have two legs with bent knees. Make sure to squeeze and adjust the towel so it’s less uneven. You can also add some tape around the towel to give it more shape.
Next, take the pillows you collected earlier and place the smaller pillows on the bed, facing the back of the suit. Tuck the pillows into the suit, including the arm and leg areas. Then, zip up the suit, one zipper at a time, tucking in the pillows and giving them shape. This model was specifically selected for its fabric, shape, and accessibility to ensure a snug fit.
